How to Apply UVDTF Stickers

UVDTF stickers are simple to apply and only take a few minutes. Follow these steps, and you will get a great result every time.

Step 1 - Clean your surface
Wipe the surface with an alcohol wipe or a clean, dry cloth. Make sure there is no dust, oil or moisture. This helps the sticker stick properly. UVDTF stickers work on glass, ceramic, metal, plastic, leather and wood.

Step 2 - Cut your sticker
Cut around your design with scissors. Leave a small border around the edge. Do not remove the clear film on top yet.

Step 3 - Peel the white backing
Flip the sticker over and peel off the white paper from the back. Your design will stay on the clear film. If the sticker starts to lift off the film, press it back down gently.

Step 4 - Stick it down
Place the sticker onto your surface with the design facing down. Press firmly with your fingers, starting from the middle and working outward. This pushes out any air bubbles.

Step 5 - Remove the clear film
Slowly peel back the clear film. Pull it at a low angle, not straight up. If any part of the sticker lifts with the film, press it back down and wait a little longer before trying again.

That's it! Your sticker is now on and ready to go. It is waterproof and scratch-resistant.

Any questions? Email us at hello@purepack.com.au